High-speed circular saws are widely used in various industries, so their uses are definitely very wide. Before each use of the high-speed circular saw, make sure that the safety cover of the circular saw blade is intact. Its saw blade is installed correctly, otherwise it will shorten the life of the saw blade and it will break badly during sawing. Or before everyone saws, the high-speed circular saw must check whether the object being cut is clamped to ensure the safety of sawing. After the saw blade is worn, it should be stopped immediately and can only be used after grinding and trimming. During use, if the machine fails, press the emergency stop switch, the machine will stop, and it can only be used after the abnormality is eliminated. Of course, please strictly abide by the relevant regulations when using the high-speed circular saw, and do not operate in violation of regulations to avoid unforeseen accidents. It should be noted that when the equipment is running, the saw blade is in a high-speed rotating state and cannot be touched by hand or anything! The protective cover must be worn! Next, I suggest that you check the amount of lubricating oil, that is, the amount of engine oil we will use, and add oil (grease) strictly according to the lubrication diagram to maintain the right amount of oil and smooth flow of the oil circuit.
No rust, no root oil, no "yellow robe", no scratches on the smooth surface. Check whether the color of the engine oil has changed or deteriorated. At the same time, you should also look at the appearance, whether the components are intact, and ensure the safety device to make it safe and reliable. In addition to these places, you should also pay attention to the power supply when operating the high-speed circular saw machine. Like a solid bar metal circular saw machine, check the power cord, check the motor wiring, and whether the electrical device is short-circuited. This is the normal startup state. For users, in fact, everyone has finished reading it. We can make the metal circular saw machine run by moving the motor, but this can only be idling, not directly running. After the idling time reaches 10 minutes, check and adjust the main transmission components of the high-speed circular saw machine to ensure normal operation, whether the belt direct drive is tight, whether the installation direction and spacing of the circular saw blade are correct, and whether there is any looseness; at this time, it is also necessary to check and adjust the hydraulic system to make the handle flexible, "clamping", "lifting", "feeding", "returning" and "relaxing" accurate, the hydraulic oil is not lower than the scale line, the pump works reliably, and there is no leakage in the hydraulic pipeline; check and adjust the cooling system of the high-speed circular saw machine to ensure that the coolant is sufficient, free of impurities, deterioration or leakage.
After the introduction of the above content, we have also learned about the precautions for the operation of the high-speed circular saw machine. Other knowledge points will continue to be updated in the next issue. If you have time, remember to come and watch. There are customer service staff here to receive you 24 hours a day. Over the years, the company has been committed to the expansion and development of domestic and foreign markets, using online Internet e-commerce platforms and offline physical sales in parallel.
